The balanced rotating assembly (typically includes crankshaft, pistons, rings, connecting rods, rod bearings, and balancer) featured in this engine:

• 3.000" crank 
• 5.090" rods with ARP rod bolts
• 8½ to 1 compression pistons

More special features of this engine include:

• Seasoned block that has been vatted, magnafluxed for cracks, thermal cleaned and steelabrated, bored, honed and plateau honed to fit new flat top oversized pistons
• Deck head gasket surface on block to ensure a good long lasting seal
• New Hydraulic flat tappet cam to put the focus on low end and midrange power
• Cast iron heads have 3-angle valve job
• Heads have 1.780"Int/1.450"Exh valves
• Both heads have been resurfaced to ensure a good long lasting seal
• New Hardened exhaust seats for use with leaded or unleaded fuel
• New High performance springs set up to match cam
• New Valve seals
• New Valve guides
• New Screw-in rocker studs
• New 1.6 roller tip rocker arms with balls and nuts
• New Oversize pistons and rings
• New Heavy duty double row timing set
• New High volume oil pump
• New Brass expansion plugs
• New Main and rod bearings to fit 3.000" stroke crankshaft
• New Edelbrock Performer aluminum intake manifold
• All parts are painted separately before assembly for that show quality look

This engine comes completely assembled with rear sump oil pan, dipstick and dipstick tube, timing cover, harmonic balancer, valve covers, and Edelbrock aluminum intake manifold.

This Is A Real Turnkey Engine

This engine has been started on gas and run. The camshaft has been broken in and the valves adjusted. The 4150 throttle body and timing has been initially set, but should be checked after installing in vehicle.

Also included and installed on engine:

• New EZ-EFI^® self tuning fuel system. Complete package including ecu, throttle body, fuel rails, wide band O₂ sensor, wiring harness, fuel injectors, and electric fuel pump. The easy to use setup wizard provides a comprehensive walk through and the system tunes itself.
• New Electric fuel pump.
• New Fuel regulator
• Chrome air cleaner
• Fuel filter
• Electronic distributor and coil
• Spark plugs and spark plug wires
• Water pump
• Crankshaft and water pump pulleys
• Alternator with bracket and alternator belt
• Starter
• Water outlet and thermostat
• Starter alignment plate for back of block
• A/T Flexplate with bolts
• This engine has been started on gas and run. The 4150 throttle body and timing has been initially set, but should be checked after installing in vehicle.

Not included on this engine:

Exhaust manifolds, hoses, fan, accessory belts (except alternator belt), radiator, linkage or miscellaneous.

This engine is custom built from start to finish in our state of the art facility by professionals that take pride in their work to guarantee that you get a top quality engine the first time!.